Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Clutch System: Flywheel: Installation

Install flywheel and ST.
ST 498497100 CRANKSHAFT STOPPER

Fig 1: Identifying Flywheel & ST
Tighten the flywheel attaching bolts to the specified torque.
NOTE: Tighten flywheel installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross fashion.

Tightening torque:
1. 72 N-m (7.3 kgf-m, 52.8 ft-lb)
  
  Fig 2: Identifying Crisscross Tightening Sequence
2. Install clutch disc and cover. See Clutch Disc and Cover .
3. Install transmission assembly. MANUAL TRANSMISSION ASSEMBLY .

Chapter Navigation

Return to Chapter: Flywheel

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.