2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Automatic Transmission Assembly: Removal

WARNING: This page is about a different car, the 2003 Subaru Outback, 2003 Subaru Legacy, and 2003 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the vehicle on a lift.
  2. Open front hood fully, and support with stay.
  3. Disconnect battery ground cable.
  4. Remove air intake duct.

    2.5 L model 

    1. < Ref. to REMOVAL , Air Intake Duct .>

    3.0 L model 

    1. < Ref. to REMOVAL , Air Intake Duct .>
  5. Remove air cleaner case or air intake chamber.

    2.5 L model 

    1. < Ref. to REMOVAL , Air Cleaner Case.>

    3.0 L model 

    1. < Ref. to REMOVAL , Air Intake Chamber.>
  6. Remove air cleaner case stay.
    Fig 1: Removing Air Cleaner Case Stay
    G02875725Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the following connectors.
    1. Transmission harness connector
      Fig 2: Disconnecting Transmission Harness Connector
      G02875726Courtesy of SUBARU OF AMERICA, INC.
    2. Transmission ground terminal
  8. Remove starter. <Ref. to REMOVAL , Starter.>
  9. Remove pitching stopper.
    Fig 3: Removing Pitching Stopper
    G02875727Courtesy of SUBARU OF AMERICA, INC.
  10. Separate torque converter clutch from drive plate.
    1. Remove service hole plug.
    2. Remove bolts which hold torque converter clutch to drive plate.
    3. While rotating the engine, remove other bolts using ST.
      CAUTION: Be careful not to drop bolts into torque converter clutch housing.
      1. ST 499977100 CRANK PULLEY WRENCH
      Fig 4: Separating Torque Converter Clutch From Drive Plate
      G02875728Courtesy of SUBARU OF AMERICA, INC.
  11. Install ST to torque converter clutch case.
    1. ST 498277200 STOPPER SET
    Fig 5: Installing ST To Torque Converter Clutch Case
    G02875729Courtesy of SUBARU OF AMERICA, INC.
  12. Remove ATF level gauge.
    NOTE: Plug opening to prevent entry of foreign particles into transmission fluid.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.