Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Ignition Timing

IGNITION TIMING ⁽¹⁾ (Degrees BTDC @ RPM)

Application

Auto. Trans.

Man. Trans.

2.2L & 2.5L

15 @ 700

10 @ 650

3.0L ⁽²⁾

10 @ 600

.....

⁽¹⁾	To improve stability, timing is controlled while engine is idling. Timing range is plus or minus 8 degrees.

⁽²⁾	Timing must be checked using a scan tool.

Chapter Navigation

Return to Chapter: Ignition System

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.