2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Inhibitor Switch: Removal

  1. Move select lever to neutral position.
  2. Remove air intake chamber and duct.
  3. Disconnect inhibitor switch connector.
    Fig 1: Disconnecting Inhibitor Switch Connector
    G02037022
  4. Remove center exhaust pipe.
  5. Remove snap pin from range select lever.
    Fig 2: Removing Snap Pin From Range Select Lever
    G02037023
  6. Remove plate assembly from transmission case.
    Fig 3: Removing Plate Assembly From Transmission Case
    G02037024
  7. Remove bolts.
    Fig 4: Removing Bolts
    G02037025
  8. Move range select lever to parking position (left side).
    Fig 5: Moving Range Select Lever To Parking Position (Left Side)
    G02037026
  9. Removing inhibitor switch from transmission.
    Fig 6: Removing Inhibitor Switch From Transmission
    G02037027
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.