Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Inhibitor Switch: Installation
- Install inhibitor switch to transmission case.
- Move range select lever to neutral position.
- Using ST, tighten bolts of inhibitor switch. ST 499267300 STOPPER PIN
- Install select cable to range select lever.
- Install plate assembly to transmission.
Tightening torque:
- T: 24.5 N-m (2.50 kgf-m, 18.1 ft-Ib)
- Install snap pin to range select lever.
- Install center exhaust pipe.
- Connect inhibitor switch connector.
- Install air intake chamber and duct.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.