2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Clear Memory Mode

  1. On the << Main Menu >> display screen, select the {2. Each System Check} and press the [YES] key.
  2. On the << System Selection Menu >> display screen, select the {Transmission Control System} and press the [YES] key.
  3. Press the [YES] key after displayed the information of engine type.
  4. On the << Transmission Diagnosis >> display screen, select the {Clear Memory} and press the [YES] key.
  5. When the `Done' and `Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
    NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL. With 2.5 L engine, see SUBARU SELECT MONITOR (SSM) PROCEDURE . With 3.0 L engine, see SUBARU SELECT MONITOR (SSM) PROCEDURE .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.