Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Select Cable: Removal
- Prior to removal, set lever to "N" position.
- Remove under cover.
- Remove rear exhaust pipe and muffler.CAUTION: When removing exhaust pipes, be careful each exhaust pipe does not drop out.
- Remove heat shield cover.
- Remove Snap Pin from range select lever.
- Remove plate assembly from transmission case.
- Disconnect cable from select lever and then remove cable bracket.
- Remove select cable from plate assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.