2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

MT Gear Shift Lever: Removal

  1. Remove gear shift knob.
  2. Remove console box. See REMOVAL .
  3. Remove boot plate from body.
    Fig 1: Removing Boot Plate From Body
    G02036918
  4. Remove rear exhaust pipe and muffler.
  5. Remove heat shield cover.
    Fig 2: Removing Heat Shield Cover
    G02036919
  6. Remove stay from transmission bracket.
    Fig 3: Removing Stay From Transmission Bracket
    G02036920
  7. Remove rod from joint.
    Fig 4: Removing Rod From Joint
    G02036921
  8. Remove cushion rubber from body.
    Fig 5: Removing Cushion Rubber From Body
    G02036922
  9. Remove joint and then extract straight pin.
    Fig 6: Removing Joint & Extracting Straight Pin
    G02036923
  10. Remove gear shift lever.
    Fig 7: Removing Gear Shift Lever
    G02036924
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.