2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Oil: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Drain engine oil by loosening engine oil drain plug.
    Fig 1: Identifying Drain Plug
    G02113470
  2. Open engine oil filler cap for quick draining of the engine oil.
    Fig 2: Opening Engine Oil Filler Cap To Drain Engine Oil
    G02113471
  3. Replace drain plug gasket.
  4. Tighten engine oil drain plug after draining engine oil.
    1. Tightening torque:  44 N.m (4.5 kgf-m, 33 ft-lb)
    Fig 3: Tightening Drain Plug
    G02113472
  5. Fill engine oil through filler pipe up to upper point on level gauge. Make sure that vehicle is placed level when checking oil level. Use engine oil of proper quality and viscosity, selected in accordance with the table in figure.

    Recommended oil 

    1. API classification 
    2. SJ or SH with the words "Energy Conserving or Energy conserving II", CCMC specification G4 or G5, ACEA specification A1, A2 or A3, or New API mark displayed on the container (If it is impossible to get SJ or SH grade, you may use SG grade). 

    Engine oil capacity (excludes oil filter): 

    1. Upper level:  5.5 l (5.8 US qt, 4.8 Imp qt)
    2. Lower level:  4.5 l (4.8 US qt, 4.0 Imp qt)
    Fig 4: Viscosity/Temperature Chart
    G02113473

    The proper viscosity helps vehicle get good cold and hot starting by reducing viscous friction and thus increasing cranking speed.

    CAUTION: When replenishing oil, it does not matter if the oil to be added is a different brand from that in the engine; however, use oil having the API classification and SAE viscosity No. designated by SUBARU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.