2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal And Installation

WARNING: This page is about a different car, the 2001 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery ground cable.
    Fig 1: Disconnecting Battery Ground Cable
    G02001230
  2. Remove side sill front cover.
    Fig 2: Removing Side Sill Front Cover
    G02001231
  3. Detach floor mat of front passenger seat.
    Fig 3: Detaching Floor Mat Of Front Passenger Seat
    G02001232
  4. Remove protect cover.
    Fig 4: Removing Protect Cover
    G02001233
  5. Remove nuts which hold ECM to bracket.
    Fig 5: Removing Nuts Which Hold ECM To Bracket
    G02001234
  6. Remove clip from bracket.
    Fig 6: Removing Clip From Bracket
    G02001235
  7. Disconnect ECM connectors.
    Fig 7: Disconnecting ECM Connectors
    G02001236
  8. Take out ECM.
    Fig 8: Removing ECM
    G02001237
  9. Install in the reverse order of removal.
    CAUTION: When replacing ECM, be careful not to use the wrong specification. ECM to avoid any damage to the fuel injection system.
Chapter Navigation
Return to Chapter: Engine Control Module
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.