2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Starter Specifications

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Subaru Outback, 2004 Subaru Legacy, 2003 Subaru Outback, 2003 Subaru Legacy, and 2002 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For additional starter specifications, see Fig 1 .
STARTER SPECIFICATIONS

Application Specifications
Brush Length
Standard .59" (15 mm)
Limit .39" (10 mm)
Brush Spring Force
Standard (New) 4 Lbs (19 N)
Limit 2 Lbs (7 N)
Commutator Run-Out
Standard .0008" (.02 mm) or less
Service Limit Less than .0020" (.05 mm)
Depth Of Segment Mold
Standard .024" (.6 mm)
Limit .008" (.2 mm)
Fig 1: Starter Specifications
G00351688Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.