Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 238 (Lighting System): General Description: Specifications
WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
SPECIFICATIONS CHART
| Headlight | 12 V - 55 W (Low) 12 V - 55 W (High) |
GT, OUTBACK, PICKUP | |
|---|---|---|---|
| 12 V - 55/65 W (Low/High) | Except PICKUP | ||
| Front turn signal light, side turn signal light, parking light | 12 V - 27/8 W | - | |
| Front fog light | 12 V - 51 W | OUTBACK, PICKUP | |
| 12 V - 55 W | Except PICKUP | ||
| Rear combination light | Tail/Stop/Turn signal light | 12 V - 21/5 W | PICKUP |
| Tail/Stop light | 12 V - 27/8 W | Except PICKUP | |
| Turn signal light | 12 V - 21 W | Except PICKUP | |
| Back-up light | 12 V - 21 W | PICKUP | |
| 12 V - 27 W | Except PICKUP | ||
| Rear finisher light | Tail/Stop light | 12 V - 27/8 W | Except PICKUP |
| Tail light | 12 V - 5 W | PICKUP | |
| Back-up light | 12 V - 27 W | Except PICKUP | |
| License plate light | 12 V - 5 W | - | |
| High-mounted stop light | 12 V - 16 W | SEDAN | |
| 12 V - 13 W | Except PICKUP | ||
| Room light | 12 V - 8 W | - | |
| Spot light | 12 V - 8 W | - | |
| Door step light | 12 V - 3.4 W | - | |
| Luggage room light | 12 V - 13 W | WAGON | |
| Trunk room light | 12 V - 5 W | SEDAN | |
| Glove box light | 12 V - 1.4 W | - | |
| Cargo light | 12 V - 13 W | PICKUP | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
