2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Lever: Installation

WARNING: This page is about a different car, the 2004 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount the select lever onto the vehicle body.
  2. Tighten the four bolts to install the select lever to the vehicle body, then connect connector.

    Tightening torque: 

    13 N.m (1.3 kgf-m, 9.4 ft-lb) 

    Fig 1: Installing Select Lever Assembly
    G00957370Courtesy of SUBARU OF AMERICA, INC.
  3. Install the console box. < Ref. to INSTALLATION , Console Box. >
  4. Set location of the select lever at "N" range.
  5. Lift-up the vehicle.
  6. Set location of the range select lever to "N" range.
  7. Insert the thread portion of the other inner cable and into the connector hole of the select lever, and fix the other outer cable end to the bracket.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  8. Adjust the select cable position. < Ref. to ADJUSTMENT , Select Cable. >
  9. After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
  10. Install the heat shield cover. (If equipped)
  11. Install the rear exhaust pipe and muffler:

    SOHC  model:

    < Ref. to INSTALLATION , Rear Exhaust Pipe. > and

    < Ref. to INSTALLATION , Muffler. >

    DOHC turbo  model:

    < Ref. to INSTALLATION , Rear Exhaust Pipe. > and

    < Ref. to INSTALLATION , Muffler.>

  12. Inspect the following items. If the following inspection reveals problems, adjust the select cable and inhibitor switch. < Ref. to ADJUSTMENT , Select Cable > and < Ref. to ADJUSTMENT , Inhibitor Switch. >
    1. The engine starts operating when select lever is in range "P" and "N", but not in other ranges.
    2. The back-up light is lit when the select lever is in range "R", but not in other ranges.
    3. Select lever and indicator ranges are matched.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.