2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

WARNING: This page is about a different car, the 2004 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the vehicle on a lift.
  2. Set the select lever to "N" range.
  3. Disconnect negative cable from battery.
  4. Lift-up the vehicle.
  5. Remove the front, center, rear exhaust pipe and muffler. (SOHC model)  :

    < Ref. to REMOVAL , Front Exhaust Pipe >,

    < Ref. to REMOVAL , Center Exhaust Pipe >,

    < Ref. to REMOVAL , Rear Exhaust Pipe > and

    < Ref. to REMOVAL , Muffler >

  6. Remove the center and rear exhaust pipes and muffler. (DOHC turbo model)  :

    < Ref. to REMOVAL , Center Exhaust Pipe >,

    < Ref. to REMOVAL , Rear Exhaust Pipe > and

    < Ref. to REMOVAL , Muffler >

  7. Remove the heat shield cover. (If equipped)
    Fig 1: Removing Heat Shield Cover (If Equipped)
    G00957382Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the snap pin and washer from range select lever.
    Fig 2: Removing Snap Pin & Washer From Range Select Lever
    G00957383Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the plate assembly from transmission case.
    Fig 3: Removing Plate Assembly From Transmission Case
    G00957384Courtesy of SUBARU OF AMERICA, INC.
  10. Disconnect the cable from select lever, and then remove the cable bracket.
    Fig 4: Disconnecting Cable From Select Lever & Remove Cable Bracket
    G00957385Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.