2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Combination Switch (Light): Removal

WARNING: This page is about a different car, the 2003 Subaru Outback, 2003 Subaru Legacy, and 2003 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect ground cable from battery.
  2. Remove instrument panel lower cover. < Ref. to REMOVAL , Instrument Panel Assembly.>
  3. Remove screws which secure upper column cover to lower column cover.
    Fig 1: Removing Screws Securing Upper Column Cover
    G02872790Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect connector from combination switch.
  5. Remove screws which secure switch and remove switch.
    Fig 2: Removing Screws Securing Switch
    G02872791Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.