2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 120 (Identification & Specifications): Specifications: Engine

WARNING: This page is about a different car, the 2004 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
Engine Specifications Chart

Model Turbo 2.0 L 2.5 L STi
Engine type Horizontally opposed, liquid cooled, 4-cylinder, 4-stroke gasoline engine
Valve arrangement Overhead camshaft type
Bore x Stroke mm (in) 92 x 75 (3.62 x 2.95) 99.5 x 79 (3.92 x 3.11)
Displacement cm3 (cu in) 1,994 (121.67) 2,457 (149.9)
Compression ratio 8.0 Β± 0.2 10.0 Β± 0.2 8.2 Β± 0.2
Firing order Β  1 - 3 - 2 - 4
Idle speed at Park/Neutral position rpm 750Β±100 MT: 650Β±100
AT: 700Β±100
700 Β± 100
Maximum output kW (HP)/rpm 169 (227)/6,000 123 (165)/5,600 224 (300)/6,000
Maximum torque N.m (kgf-m, ft-lb)/rpm 294 (30.0, 217)/4,000 226 (23.0, 166)/4,000 407 (41.5, 300)/4,000
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.