2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Oil: Replacement

WARNING: This page is about a different car, the 2003 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the engine oil filler cap for quick draining of the engine oil.
  2. Drain the engine oil by loosening engine oil drain plug.
    Fig 1: Draining Engine Oil
    G02621854Courtesy of SUBARU OF AMERICA, INC.
  3. Replace the drain plug gasket.
  4. Tighten the engine oil drain plug after draining engine oil.
    1. Tightening torque:  44 N.m (4.5 kgf.m, 32.5 ft.lb)
    Fig 2: Installing Engine Oil Drain Plug With New Gasket
    G02621855Courtesy of SUBARU OF AMERICA, INC.
  5. Fill engine oil through the filler pipe up to upper point on level gauge. Make sure that the vehicle is placed level when checking oil level. Use the engine oil of proper quality and viscosity, selected in accordance with the table in figure.

    Recommended oil 

    1. API classification
    2. SL, SJ or SH grade oil with the words "Energy Conserving" or "Energy Conserving II", or the new API mark indicated on the container (if SL or SJ grade oil is unavailable, use SH or SG grade oil).

    Engine oil capacity: (Non-turbo model) 

    1. Upper level;  4.0 l (4.2 US qt, 3.5 lmp qt)
    2. Lower level;  3.0 l (3.2 US qt, 2.6 lmp qt)

    Engine oil capacity: (Turbo model) 

    1. Upper level;  4.5 l (4.8 US qt, 4.0 lmp qt)
    2. Lower level;  3.5 l (3.7 US qt, 3.1 lmp qt )
    3. Fig 3: Engine Oil Recommendation Chart
      G02621856Courtesy of SUBARU OF AMERICA, INC.

    Oil of a proper viscosity ensures good cold and hot starting by reducing viscous friction and thus increasing cranking speed.

    CAUTION: When replenishing oil, it does not matter if the oil to be added is a different brand from that in the engine; however, use oil having the API classification and SAE viscosity No. specified by SUBARU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.