2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Headlight Assembly: Removal

WARNING: This page is about a different car, the 2003 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery.
  2. Remove the duct (A) (when right side headlight is removed).
    Fig 1: Removing Duct
    G01974962Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the front grille and headlight side cover.

    See REMOVAL , Front Grille and REMOVAL , Front Bumper.

  4. Disconnect the headlight bulb connector.
    Fig 2: Disconnecting Headlight Bulb Connector
    G01974963Courtesy of SUBARU OF AMERICA, INC.
  5. Remove three bolts and disconnect the connectors, and then detach the headlight assembly.
    Fig 3: Removing Bolts & Disconnecting Connectors
    G01974964Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.