2001 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Rear ABS Sensor: Installation

  1. Install rear drive shaft to the vehicle. See AXLE SHAFTS - REAR .
  2. Temporarily install rear ABS sensor on rear arm.
    CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.

    With disc brake model:Β 

    Fig 1: Temporarily Installing Rear ABS Sensor
    G02088499

    With drum brake model:Β 

    Fig 2: Temporarily Installing Rear ABS Sensor
    G02088500
  3. Install rear sensor harness brackets in the original positions and install harness on the clip.

    Tightening torque:Β 

    1. 32 N.m (3.3 kgf-m, 24 ft-lb)
    Fig 3: Installing Rear Sensor Harness Brackets
    G02088501
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.