Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2001LEGACY GT LIMITED, AUTOMATICREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSA/T CONTROL SYSTEMSSELECT CABLEREMOVAL
2001 Subaru Legacy GT Limited, Automatic
Select Cable: Removal
2001 Subaru Legacy GT Limited, AutomaticSECTION Removal
- Prior to removal, set lever to "N" position.
- Remove under cover.
- Remove rear exhaust pipe and muffler.CAUTION: When removing exhaust pipes, be careful each exhaust pipe does not drop out.
- Remove heat shield cover.
- Remove Snap Pin from range select lever.
- Remove plate assembly from transmission case.
- Disconnect cable from select lever and then remove cable bracket.
- Remove select cable from plate assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.