Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2001LEGACY GT LIMITED, AUTOMATICREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSA/T CONTROL SYSTEMSSELECT CABLEINSTALLATION

2001 Subaru Legacy GT Limited, Automatic

Select Cable: Installation

2001 Subaru Legacy GT Limited, AutomaticSECTION Installation

Install select cable to plate assembly.
Tightening torque:
1. 32 N.m (3.3 kgf-m, 24 ft-lb)
Install select cable to range select lever.
Install plate assembly to transmission.
Tightening torque:
1. T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
  
  Fig 1: Installing Plate Assembly
Install snap pin to range select lever.

Fig 2: Installing Snap Pin
Move the select lever to the "N" position, then adjust the select cable position. See ADJUSTMENT .
Install heat shield cover.

Fig 3: Installing Heat Shield Cover
Install rear exhaust pipe to muffler.
Install under cover.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.