2001 Subaru Forester L, AutomaticFACTORY OEM SERVICE PROCEDURE

Test 9: Checking Security Control Module

  1. Check that security control module is securely fastened to its mountings. Secure as needed and go to next step.
  2. Remove security module. See SECURITY CONTROL MODULEΒ  under REMOVAL & INSTALLATION. Remove plug on module housing and adjust sensitivity. Install security module. Turning screw clockwise increases sensitivity and turning counterclockwise decreases sensitivity. Install security module. Close liftgate and all windows. Arm system. Hit center of windshield with palm of hand. If horn chirps, test is complete. If horn does not chirp, readjust sensitivity setting.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.