2001 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Transfer Clutch: Assembly

  1. Install the transfer clutch piston.
    Fig 1: Installing Transfer Clutch Piston
    G02003423
  2. Install return spring to transfer piston.
    Fig 2: Installing Return Spring To Transfer Piston
    G02003424
  3. Install transfer clutch piston seal.
    Fig 3: Installing Transfer Clutch Piston Seal
    G02003425
  4. Install ST to rear drive shaft.

    ST 499257300 SNAP RING OUTER GUIDE

    Fig 4: Installing (ST) To Rear Drive Shaft
    G02003426
  5. Install snap ring to ST.

    ST 499257300 SNAP RING OUTER GUIDE

    Fig 5: Installing Snap Ring To (ST)
    G02003427
  6. Using ST1 and ST2, install snap ring to rear drive shaft.
    NOTE: After installing snap ring, remove ST1 and ST2.

    ST1 499257300 SNAP RING OUTER GUIDE

    ST2 499247400 INSTALLER

    Fig 6: Installing Snap Ring To Rear Drive Shaft
    G02003428
  7. Install the driven plates, drive plates, pressure plate and snap ring.
    Fig 7: Installing Driven Plates & Related Components
    G02003429
  8. Apply compressed air to see if the assembled parts move smoothly.
    Fig 8: Checking Assembled Parts For Smooth Operation
    G02003430
  9. Check the clearance.
    NOTE: Before measuring clearance, place the same thickness of shim on both sides to prevent pressure plate from tilting.
    If the clearance is not within the specified range, select a proper pressure plate.

    Standard value:Β  0.2 - 0.6 mm (0.008 - 0.024 in)

    Allowable limit:Β  1.6 mm (0.063 in)

    Fig 9: Measuring Pressure Plate Clearance
    G02003431
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.