Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Switch Test
Remove power mirror switch from center console. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Disconnect mirror switch connector. Check continuity between specified terminals of switch connector, with switch button in specified position(s). See Fig 1 . See POWER MIRROR SWITCH CONTINUITY TEST table. Replace switch if continuity is not as specified.
| Switch Position | Terminal No. | ||||||
|---|---|---|---|---|---|---|---|
| Changeover Switch | (1) | ||||||
| Mirror Switch (2) | |||||||
| Left Mirror | |||||||
| Up | 1 & 2; 4 & 7 | ||||||
| Down | 1 & 4; 2 & 7 | ||||||
| Left | 1 & 2; 4 & 9 | ||||||
| Right | 1 & 4; 2 & 9 | ||||||
| Right Mirror | |||||||
| Up | 1 & 2; 4 & 6 | ||||||
| Down | 1 & 4; 2 & 6 | ||||||
| Left | 1 & 2; 4 & 8 | ||||||
| Right | 1 & 4; 2 & 8 | ||||||
|
|||||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.