2001 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Keyless Transmitter

NOTE: Procedure must be performed within 45 seconds.
  1. Perform test sitting in driver's seat. Ensure all doors, rear gate or trunk are closed. Open and close driver's door. Turn ignition switch from ON to LOCK position 10 times in rapid succession (within 15 seconds). DO NOT start engine. Horn will chirp once, indicating system is in programming mode.
  2. Open and close driver's door. Press any button on transmitter that needs to be programmed. Horn will sound 2 times, indicating remote transmitter has been programmed. To program additional transmitter(s), repeat this step. After programming transmitter(s), go to next step.
  3. Remove ignition key from switch. Horn will chirp 3 times, indicating that system has exited programming mode. Ensure each transmitter operates properly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.