2000 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Camber Adjustment: Rear

Camber is not adjustable. If camber measurement is not within specification, check for frame damage, lateral link damage or worn out components (struts/springs, joints, etc.).

Fig 1: Adjusting Front Camber
G92G01700Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.