2000 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Component Disassembly & Reassembly: Notes

NOTE: For exploded views of internal parts, thrust washer and thrust needle bearing locations, see Figure -Figure . Lubricate all parts with transaxle fluid during reassembly. Thrust washers, thrust needle bearings and gaskets should be held in place with petroleum jelly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.