2000 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Except Outback

WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove two clips and lower the mudguard.
    Fig 1: Removing Front Fog Light Assembly Clips (Except Outback)
    G02098018
  2. Disconnect harness connector.
  3. Remove mounting bolts, and then detach fog light assembly.
    Fig 2: Detaching Fog Light Assembly (Except Outback)
    G02098019
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.