Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transmission Assembly: Installation
WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install rear cushion rubber to transmission assembly.
Tightening torque:
- 38 N.m (3.9 kgf-m, 28 ft-lb)
- Install ST to torque converter clutch case.
ST 498277200 STOPPER SET
- Install transmission onto engine.
- Gradually raise transmission with transmission jack.
- Engage them at splines.
- Install transmission rear crossmember.
Tightening torque:
- T1: 35 N.m (3.6 kgf-m, 26 ft-lb)
- T2: 75 N.m (7.6 kgf-m, 55 ft-lb)
- Take off transmission jack.
- Tighten nuts which hold lower side of transmission to engine.
Tightening torque:
- 50 N.m (5.1 kgf-m, 36.9 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.