2000 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
Back-Up Light Switch (M/T) On transfer case.
Brake Fluid Level Switch In brake master cylinder.
Clutch Switch On clutch pedal bracket.
Evaporation Thermoswitch Behind right side of dash, on intake unit case.
Inhibitor Switch On right side of transmission case. See Figure.
Neutral Position Switch On transfer case.
Oil Pressure Switch On top front of right cylinder head.
Parking Brake Switch At base of parking brake lever.
Power Steering Oil Pressure Switch On power steering oil pump.
"P" Position Switch At base of selector lever.
Pressure Switch On A/C receiver-drier.
Seat Belt Switch In seat belt buckle.
Stoplight Switch On brake pedal bracket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.