2000 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS

Component Component Location
Blower Motor Resistor Behind right side of dash.
Check Connector At center of dash.
Data Link Connector (DLC) At center of dash.
Diagnosis Connector At center of dash.
Diagnosis Terminal At center of dash.
Diode (Courtesy Light) Behind right side of dash.
Diode (Front Foglight) Behind left side of dash.
Diode (Rear Gate) Behind right side of dash.
Drain Valve At right rear of vehicle, near canister.
Dropping Resistor At right side of engine compartment. See Figure.
Ignition Coil & Ignitor On top front of engine.
OP Connector Behind center of dash.
Rear Defogger Condenser At right front corner of trunk.
Security Horn At right side of engine compartment. See Figure.
Test Mode Connector Behind center of dash.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.