2000 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Test 11: Stoplight Switch Problem

  1. Press brake pedal. If stoplights illuminate, go to next step. If stoplights do not illuminate, repair stoplight circuit.
  2. Turn ignition off. Disconnect ABSCM/HU connector. Press brake pedal. Measure voltage between ground and ABSCM/HU connector terminal No. 2. If voltage is 10-15 volts, go to next step. If voltage is not 10-15 volts, repair wiring harness between stoplight switch and ABSCM/HU.
  3. Check stoplight switch and ABSCM/HU connector contacts. Repair contacts as needed. Go to next step.
  4. Reconnect all connectors. Erase memory. Recheck for trouble codes. If same trouble code returns, replace ABSCM/HU. If other trouble codes exist, go to proper test procedure. If no trouble codes exist, problem was a temporary poor contact. Recheck harness and connectors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.