1999 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS

Component Component Location
Antenna Amplifier At left rear corner of cargo compartment.
A/T Dropping Resistor On right side of engine compartment.
Blower Motor Resistor Behind right side of dash.
Check Connector Under left side of dash.
Data Link Connector (DLC) On dash, left of steering column. See Figure.
Diagnosis Connector Behind left side of dash.
Diagnosis Terminal (Ground) Behind left side of dash.
Diode (Luggage Room Light) At right rear corner of cargo compartment.
Ignition Coil On top center of engine. See Figure.
Joint Connector (E/G) Behind right side of dash.
Mirror Heater Condenser Behind right side of dash.
Noise Killer (Audio) Behind left side of dash.
Resistor (DRL) Behind right side of dash.
Shield Joint Connector (ABS) At right front corner of engine compartment.
Shield Joint Connector (A/T) Behind left side of dash.
Test Mode Connector Behind left side of dash. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.