Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998FORESTER L, STANDARDREPAIR AND DIAGNOSISELECTRICALSTARTERON-VEHICLE TESTINGIGNITION SWITCH TESTSTART CIRCUIT TEST
1998 Subaru Forester L, Standard
Start Circuit Test
1998 Subaru Forester L, StandardSECTION Start Circuit Test
- Remove lower instrument panel below steering column. Remove air duct. Disconnect ignition switch harness connector.
- Using jumper wire, apply 12 volts to ignition switch terminal "B". See Figure. Connect test light to switch terminal "S". Turn ignition switch to START position. If test light does not illuminate, replace ignition switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.