Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998FORESTER BASEREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSWITCHES
1998 Subaru Forester Base
Electrical Component Locator: Switches
1998 Subaru Forester BaseSECTION Switches
SWITCHES
| Component | Component Location |
|---|---|
| A/C Pressure Switch | On right rear of engine compartment, on accumulator. |
| Back-Up Light Switch (M/T) | On left side of transmission. |
| Brake Fluid Level Switch | On brake fluid reservoir. |
| Clutch Switch (Cruise) | On bracket, above clutch pedal. |
| Clutch Switch (M/T) | On bracket, above clutch pedal. |
| Evaporator Thermoswitch | Behind right side of dash, on A/C-heater module. |
| Inhibitor Switch (A/T) | On right side of transmission. See Figure. |
| Neutral Position Switch (M/T) | On left side of transmission. |
| Oil Pressure Switch | On upper right front of cylinder block. |
| Parking Brake Switch | On base of parking brake lever. |
| Parking Position Switch & Shift Lock Solenoid (A/T) | At base of shift lever. |
| Seat Belt Switch | In driver's seat belt buckle. |
| Stop & Brake Switch (Cruise) | On bracket, above brake pedal. |
| Stop Light Switch | On bracket, above brake pedal. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.