Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Subaru SVX LSiFACTORY OEM SERVICE PROCEDURE
Security Control Module I/O Signals
To identify security control module input terminals and function. See SECURITY CONTROL MODULE I/O SIGNALS table. SeeFig 1 .
SECURITY CONTROL MODULE I/O SIGNALS
| Pin No. | Circuit |
|---|---|
| 1 | Passenger's Door Latch |
| 2 | Driver's Door Latch |
| 3 | Security Switch |
| 4 | Trunk Lid Switch |
| 5 | Ignition Switch |
| 6 | Key Switch |
| 7 | Open |
| 8 | Ground |
| 9 | Voltage Supply |
| 10 | Parking Light |
| 11 | LED Positive Voltage |
| 12 | LED Negative Voltage |
| 13 | Starter |
| 14 | Door Lock Actuator (Unlock) |
| 15 | Door lock Actuator (Lock) |
| 16 | Horn |
| 17 | Open |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
