1997 Subaru Legacy Outback, AutomaticFACTORY OEM SERVICE PROCEDURE

DTC P0133 (FO2_R): Front O2S Circuit Slow Response

If DTC P0130 exists, diagnose DTC P0130Β  first. Clear DTC and retest. If DTC P0133 resets, check exhaust system and repair as necessary. If exhaust system is okay, replace front O2S.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.