Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing: Sub-Switch
Remove power window sub-switch from door panel. Disconnect harness connector. Continuity should exist between specified switch terminals with switch in specified position. See SUB-SWITCH CONTINUITY TEST . SeeFig 1 . If continuity does not exist between specified terminals, replace power window sub-switch.
| Switch Position | Terminal No. | Wire Color | |
|---|---|---|---|
| Right Front | |||
| Up | 1 & 4 | BLK/BLU & BLU/RED | |
| Up | 2 & 5 | BLU & BLK/YEL | |
| Off | 1 & 4 | BLK/BLU & BLU/RED | |
| Off | 2 & 3 | BLU & RED/BLK | |
| Down | 2 & 3 | BLU & RED/BLK | |
| Down | 4 & 5 | BLU/RED & BLK/YEL | |
| Right Rear | |||
| Up | 2 & 5 | BLU & BLK/YEL | |
| Up | 3 & 4 | GRY/WHT & BLU/RED | |
| Off | 1 & 2 | BLU/WHT & BLU | |
| Off | 3 & 4 | GRY/WHT & BLU/RED | |
| Down | 1 & 2 | BLU/WHT & BLU | |
| Down | 4 & 5 | BLU/RED & BLK/YEL | |
| Left Rear | |||
| Up | 2 & 5 | BLU & BLK/YEL | |
| Up | 3 & 4 | GRY/BLK & BLU/RED | |
| Off | 1 & 2 | GRY/YEL & BLU | |
| Off | 3 & 4 | GRY/BLK & BLU/RED | |
| Down | 1 & 2 | GRY/YEL & BLU | |
| Down | 4 & 5 | BLU/RED & BLK/YEL | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.