Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Subaru Impreza OutbackFACTORY OEM SERVICE PROCEDURE
Valve Clearance: Notes
- Disconnect battery ground. Raise and support vehicle. To inspect and adjust cylinder No. 1 and No. 3, remove right side timing belt cover. Disconnect connector from mass air flow sensor. Remove upper air intake duct and upper air cleaner cover as a unit. Remove air filter. Remove spark plug wires from cylinders No. 1 and No. 3. Remove under cover from right side. Remove valve cover.
- To inspect and adjust cylinders No. 2 and No. 4, disconnect washer motor connectors. Disconnect hose and plug connection. Remove washer tank bolts and secure away from work area. Disconnect No. 2 and No. 4 spark plug wires. Remove left side under cover. Disconnect PCV hose from valve cover. Remove valve cover.
- Set No. 1 cylinder to TDC of compression stroke. Arrow mark on right side camshaft sprocket should be pointing straight up. See Fig 1 . Using Feeler Gauge, measure No. 1 cylinder valve clearance. Adjust as needed. Tighten locknut to 86-95 INCH lbs. (9-10 N.m). See the VALVE CLEARANCE SPECIFICATIONΒ table.
- Set cylinders No. 3, No. 2 & No. 4 to TDC by turning crankshaft pulley clockwise 90 degrees until arrow lines up to appropriate cylinder See Fig 1 . Reinstall parts removed in reverse order.
VALVE CLEARANCE SPECIFICATION
| Application | Clearance: In. (mm) |
|---|---|
| Intake | .0001-.0087 (.18-.22) |
| Exhaust | .0090-.0106 (.23-.27) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
