1997 Subaru Impreza OutbackFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor

NOTE: All testing procedures are performed with engine at normal operating temperature. For further TP sensor diagnosis, see the TESTS W/CODES article.
  1. Turn ignition on. With throttle fully closed, check and record voltage to ground at the specified ECM terminals. Refer to the TP SENSOR SPECIFICATIONSΒ  table.
  2. If necessary, loosen retaining screws and rotate TP sensor until correct voltages are obtained. Replace TP sensor if voltage cannot be adjusted to specification.
TP SENSOR SPECIFICATIONS

Throttle Position & Terminal No. Specification
Throttle Fully Closed, Terminal Nos. 6 & 20 (1) 0.4-0.5 Volts
(1) Checked by backprobing ECM harness connector terminals and with ignition on.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.