1997 Subaru Impreza OutbackFACTORY OEM SERVICE PROCEDURE

Component Testing: Sub-Switch

Remove power window sub-switch from door panel. Disconnect harness connector. Continuity should exist between specified switch terminals with switch in specified position. See SUB-SWITCH CONTINUITY TESTΒ  . SeeFig 1 . If continuity does not exist between specified terminals, replace power window sub-switch.

SUB-SWITCH CONTINUITY TEST

Switch Position Terminal No. Wire Color
Right Front
Up 3 & 4 RED & BLU
Up 1 & 2 BLU/RED & WHT/GRY
Off 1 & 2 BLU/RED & WHT/GRY
Off 4 & 5 BLU & WHT
Down 1 & 3 BLU/RED & RED
Down 4 & 5 BLU & WHT
Right & Left Rear
Up 3 & 4 BLK/BLU & BLU/RED
Up 1 & 2 BLU & GRY/WHT
Off 1 & 2 BLU & GRY/WHT
Off 4 & 5 BLU/RED & LT GRN
Down 1 & 3 BLU & BLK/BLU
Down 4 & 5 BLU/RED & LT GRN
Fig 1: Power Window Sub-Switch Terminals
G97C28714Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.