1997 Subaru Impreza OutbackFACTORY OEM SERVICE PROCEDURE

Power Window Main Switch

Remove power window main switch from driver's door panel. Disconnect harness connector. Continuity should exist between specified switch terminals with switch in specified position. See POWER WINDOW MAIN SWITCH CONTINUITYΒ  . SeeFigure . If continuity does not exist between specified terminals, replace power window main switch.

POWER WINDOW MAIN SWITCH CONTINUITY TEST

Switch Position Terminal No. Wire Color
Left Front Switch
Locked & Unlocked
Up 7 & 8 RED/BLU
Up 12 & 13 BLK & BLU/RED
Off 8, 12 & 13 BLU, BLK & BLU/RED
Down 8 & 12 BLU & BLK
Down 7 & 13 RED & BLU/RED
Right Front Switch
Locked
Up 7 & 14 RED & WHT
Off 9 & 14 WHT/GRY & WHT
Down 7 & 9 RED & WHT/GRY
Unlocked
Up 7 & 14 RED & WHT
Up 9 & 12 WHT/GRY & BLK
Off 9, 12 & 14 WHT/GRY, BLK & WHT
Down 2 & 14 BLK & WHT
Down 7 & 9 RED & WHT/GRY
Left Rear Switch
Locked
Up 5 & 7 WHT/RED & RED
Off 5 & 10 WHT/RED & WHT/YEL
Down 7 & 10 RED & WHT/YEL
Unlocked
Up 5 & 7 WHT/RED & RED
Up 10 & 12 WHT/YEL & BLK
Off 5, 10 & 12 WHT/RED, WHT/YEL & BLK
Down 7 & 10 RED & WHT/YEL
Down 5 & 12 WHT/RED & BLK
Right Rear Switch
Locked
Up 7 & 11 RED & WHT/BLU
Off 6 & 11 BLU/BLK & WHT/BLU
Down 6 & 7 BLU/BLK & RED
Unlocked
Up 7 & 11 RED & WHT/BLU
Up 6 & 12 BLU/BLK & BLK
Off 6, 11 & 12 BLU/BLK, WHT/BLU & BLK
Down 6 & 7 BLU/BLK & RED
Down 11 & 12 WHT/BLU & BLK
Fig 1: Identifying Power Window Main Switch Terminals
G97B28713Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.