Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Subaru SVX LSiFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Control Module | Under right front seat. See Figure . |
| Cruise Control Module | Behind trim panel, left of rear seat. See Figure . |
| DRL Control Module (Canada) | Behind trim panel, right of rear seat. See Figure . |
| Engine Control Module | Behind dash, left of steering column. See Figure . |
| Fan Control Amplifier | Behind glove box, on A/C-heater plenum. |
| Front Wiper Control Module | Behind dash, left of steering column. See Figure . |
| Fuel Pump & Gauge Module | On right side of luggage compartment. |
| Hydraulic Control Unit (ABS) | On lower right front of engine compartment. |
| Power Steering Control Module | Behind trim panel, right of rear seat. See Figure . |
| Security Module | In luggage compartment, under center of rear package tray. See Figure . |
| Shift Lock Control Module | Below rear of center console. See Figure . |
| Stoplamp Checker | On right side of luggage compartment. See Figure . |
| Timer Control Module | Behind right side of glove box. See Figure . |
| Transmission Control Module | Behind dash, left of steering column. See Figure . |
| Turn & Hazard Control Module | Behind dash, left of steering column. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
