Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Subaru SVX LSiFACTORY OEM SERVICE PROCEDURE
Code 41 - Air/Fuel Learning Control
NOTE:
Refer to illustration for ECM connector terminal identification. See Figure
.
- Check fuel injector operation and repair as necessary. See CODES 14, 15, 16, 17, 18 & 19 - FUEL INJECTORSΒ . If injectors are okay, check airflow sensor (Code 23) and repair as necessary. If airflow sensor is okay, check coolant temperature sensor (Code 21) and repair as necessary. If coolant temperature sensor is okay, check throttle position sensor (Code 31) and repair as necessary. If throttle position sensor is okay, check both oxygen sensors (Codes 32 and 37) and repair as necessary. If oxygen sensors are okay, go to next step.
- Check system fuel pressure. See the BASIC TESTING article. Ensure all fuel injectors are operating properly. If all components have been inspected and Code 41 is still present, check ECM connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
