Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Subaru SVX LSiFACTORY OEM SERVICE PROCEDURE
Code 21 - Coolant Temperature Sensor
NOTE:
Refer to illustration for ECM connector terminal identification. See Figure
.
- Remove collector cover and air intake boot. Disconnect coolant temperature sensor connector. Using an ohmmeter, check sensor resistance. Resistance should be 30,000 ohms at 68°F (20°C) and 400 ohms at 176°F (80°C). If resistance is as specified, go to next step. If resistance is not as specified, replace coolant temperature sensor.
- Turn ignition off. Disconnect ECM connectors. Check resistance between ECM connector terminal A3 and sensor connector terminal No. 1 (Gray/Yellow wire), and between ECM connector terminal A21 and sensor connector terminal No. 2 (Blue/Black wire)
- Resistance should be zero ohms for all circuits. If resistance is not as specified, repair appropriate circuit as necessary. If resistance is as specified, check ECM connector terminals for good contact. Repair as necessary. If connector terminals are okay, replace ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
