Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Clutch Housing Bolts | 11-15 (15-20) | |
| Drive Shaft Center Bearing Support Bolts | 25-32 (34-44) | |
| Drive Shaft-To-Differential Nuts | 13-20 (18-27) | |
| Exhaust Pipe Support Bracket Bolts | 18-25 (25-34) | |
| Exhaust Pipe-To-Engine Nuts | 18-25 (25-34) | |
| Flywheel Bolts | 51-55 (69-75) | |
| Front Crossmember Bolts | 35-63 (47-86) | |
| Mount Support Assembly Nuts | ||
| To Body | 35-51 (47-69) | |
| To Engine | 32-40 (44-54) | |
| Pressure Plate Bolts | 11-13 (15-18) | |
| Rear Crossmember | ||
| Cushion Nuts | 20-35 (27-47) | |
| Front Bolts | 87-116 (118-157) | |
| Rear Bolts | 40-61 (54-83) | |
| Stabilizer Bar-To-Transverse Link Bolts | 14-22 (19-30) | |
| Starter Bolts | ||
| Upper | 34-40 (46-54) | |
| Lower | 22-27 (30-37) | |
| Transaxle-To-Engine Bolts/Nuts | 34-40 (46-54) | |
| Transverse Link-To-Crossmember Nuts | 43-51 (58-69) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.