1995 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

Powertrain Coverage

Upon expiration of the Basic New Car Warranty, this warranty covers the following powertrain components for repairs needed to correct defects in materials or workmanship up to a maximum of 5 years or 60,000 miles, whichever occurs first.

  • Engine

    Cylinder block and internal parts, cylinder heads, valve train (including cam belts), oil pump, engine lubrication system, seals, gaskets, water pump, turbocharger (if equipped) and intake manifolds.
  • Transmission

    Transmission cases and internal parts, differential, torque converter, flywheel, pressure plate, vacuum modulator, oil seals and gaskets.
  • Front Wheel Drive Vehicles

    Axle shafts and joints (except boots), front hubs and bearings.
  • Four Wheel Drive Vehicles

    Transfer case and internal parts, drive shaft assembly (front and rear), rear differential case and internal parts, rear axle shafts and joints, rear hubs and bearings.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.