1995 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

DTC 507 (ISC_H) - Idle Control System Rpm Higher Than Expected

NOTE: Refer to illustration for connector and terminal identification. See Figure -Figure .
  1. Perform tests and repairs for DTC P0505Β  .
  2. Turn ignition to ON. Start engine and allow to idle. Check intake manifold, idle air control solenoid valve and throttle body for loose installation and gasket for cracks, by-pass hose for loose connection or cracking and vacuum hoses for disconnection or cracking. Repair as necessary. If no damage is noted, replace idle air control solenoid valve.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.