1995 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

Fuel Tank Sending Unit

Remove fuel tank sending unit. With float arm in specified position, check resistance across specified wire terminals of sending unit connector. See FUEL TANK SENDING UNIT TEST TERMINALSΒ  . Replace sending unit if resistance is not as specified. See FUEL TANK SENDING UNIT RESISTANCE SPECIFICATIONSΒ  .

NOTE: More than one Black wire may terminate at fuel tank sending unit connector. If resistance is not within specification, connect ohmmeter test lead to other Black wire terminal.
FUEL TANK SENDING UNIT TEST TERMINALS

Application Wire Colors
FWD Green & Black
AWD
Main Tank Blue & Black
Sub-Tank Green & Blue
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.