1995 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
A/C Pressure Switch On right rear of engine compartment, on accumulator. See Figure.
Brake Fluid Level Switch On brake fluid reservoir.
Clutch Switch (Cruise) On bracket, above clutch pedal.
Clutch Switch (M/T) On bracket, above clutch pedal.
Evaporator Thermoswitch Behind right side of dash, on A/C-heater module. See Figure.
FWD Switch (A/T) On right rear of engine compartment.
Hood Switch, Front (Security) On left front of engine compartment.
Inhibitor Switch (A/T) On right side of transmission.
M/T Back-Up Lamp Switch On left side of transmission.
M/T Neutral Position Switch On left side of transmission.
Oil Pressure Switch On top front of engine. See Figure.
P Position Switch (A/T) At base of shift lever.
Parking Brake Switch On base of parking brake lever.
Pedal Stroke Switch (TCS) On bracket, above brake pedal.
Seat Belt Switch In driver's seat belt buckle.
Stop & Brake Switch (Cruise) On bracket, above brake pedal.
Stop Lamp Switch On bracket, above brake pedal.
TCS Pressure Switch Right side of engine compartment.
Chapter Navigation
Return to Chapter: Electrical Component Locator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.